A1 Second spool holder (thinner)
Copyright Claim
A1 Second spool holder (thinner)
Boost
2
2
0
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
2
2
0
0
0
0
Released
Description
This is an attachment that you can use to hold a second spool on your A1. This is specifically made thinner so that it fits spools with a smaller diameter of hole.
Installation:
To install this you need to take off the rubber stop on the other side of the spool holder. This may require a pry tool.
Then simply screw the spool holder in.
Comment & Rating (0)
All
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld