Features 2 ways for your cables to enter. If mounting your camera directly over your cable's mounting point, use hole A. If mounting your camera away from the cable exit point, re-terminate your ethernet after passing it through hole B. The design also features a zip tie passthrough for strain relief.
Notes:
Note that the housing is not meant to be totally waterproof. It's designed so that if mounted to a vertical wall, rainwater should escape the housing via gravity, but you should still use the waterproofing mechanisms built into the ends of the camera cables!
Materials
ASA or ABS suggested (for outdoor applications) - I printed mine from Polymaker White ASA*
4x M4 threaded inserts* - if not using these exact inserts, verify dimensions are the same
For anyone who prints this model: I would love to update the compatibility table, but I only have one type of camera. Leave a comment on whether or not it works for your model. Appreciate it!