steelseries Aerox 3 Ultra Light Mod by 3print360

3print360

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

54 min

1 plate

Open in Bambu Studio

Boost

Released

Description

This is an ultra-light mod for the SteelSeries Aerox 3 Wired and Wireless versions. I desoldered the side buttons to save weight and because I don't use them. If you modify the wireless version, you only need to use 3 screws, while the wired version uses 4. With the wireless version, you can remove the battery to save 7g, bringing the total weight down to 29g. When removing supports, BE VERY CAREFUL!!

mouse

steelseries

Comment & Rating (5)

@Hyper

Hey, you did steal this mouse from a YouTuber "Optimum" who created this mouse back in 10.2023. Here is the source: https://www.youtube.com/watch?v=aHLzNnL81ms

@BizzyTheBear

The first thing I thought when I saw this was, wait that's Optimum's Mouse, thank you for pointing it out!

@Dwinoss

Thank you very much for this model! Several things to note: - It would be interesting to be able to have a screwing point for the right front screw, as without this there is a gap that forms between the PCB and the 3D print at this point, - I'd have to find out why I'm having printing problems when the buttons go up in height, - Show me a video or diagram of how to fit the knob, because I had a lot of trouble getting it to fit...