Plant irrigation & microdrip set by ErwinBerlin

ErwinBerlin

Household>Garden

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 4 walls, 15% infill

Designer

3.8 h

1 plate

3.5(2)

0.20mm layer, 3 walls, 50% infill

Designer

1.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Microdrip water irrigation system for plants. Ideal for those that like to automate the task of watering the plants. Ideal for balconies, and during holidays.

Tubing is 4.6mm and 6mm for the main line. The tubing can be bought at most garden centers, DIY stores and hardware stores. Can be combined with other systems. By putting the tubing in hot water it will be easier to put it on the connectors.

This set includes adapters for 6mm to 4.6mm, connectors (straight, 1 to 2 and 1 to 3) , sprinklers (90°, 180°, 360°), and drippers (adjustable, 10 & 20 ml/min).

Caps are screw for the adjustable dripper, and push on for the sprinklers.

I added a pin, so you can place the sprinklers horizontal or vertical.

And leave a 5-star rating!!

microdrip

irrigation irrigation system

irrigation

irrigation sprinkler

Comment & Rating (6)

@MooteBuilds

Boosted

Example of these models being used for drip irrigation with a 5 gallon bucket. have a different dripper at the end, because it needs some sort of terminal.

@MooteBuilds

Boosted

Print Profile

0.08mm layer, 4 walls, 15% infill

screw on and snap on heads don't fit

The designer has replied

@ErwinBerlin

Thank you for your feedback! this is a tiny print and I printed with a 0.4mm nozzle. Things to keep in mind: 1. different materials and brands have different tendencies to shrink after heating. That might have a result on the tight fit. 2. They are a tight fit and require a little wiggling to snap on. If the fit is too relaxed, there will be leaking, which I would like to avoid. Consider printing the caps in different sizes (e.g. enlarge 5 & 10%), use a 0.2mm nozzle and see how that works.

@MooteBuilds

Boosted

Replying to @ErwinBerlin :

nice models, but 4 stars simply because they don't fit exactly as they should. they are small, and work quite well, but 5 stars says that it prints as is without any issue. the print time is already pretty high for these parts. at 0.2 nozzle, it would be worse.