Transforming Fidget Ball

Transforming Fidget Ball

Boost
220
312
21

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
51.1 h
1 plate
4.0(4)

Boost
220
312
21
5
543
35
Released

Description

This is a 3D version of the popular transforming fidget which when most compact is a ball but can be squished into a long beam.

 

The mini version is now up

https://makerworld.com/en/models/482093

 

Comment & Rating (21)

Please fill in your opinion
(0/5000)

could u make one for the a1 mini
The designer has replied
5
Reply
I agree I have the a1 but I really want one that isn't ash much filament
1
Reply
Replying to @CGprints :
i want the fidget ball but only have a1 mini
1
Reply
I am working on a smaller version for people who want to print on the a1 mini or use less filament. I just have to print test it then I will upload it.
0
Reply
I scaled this down for the first print on the A1M (smallest one at the top) - it was nearly impossible to get it to squish, but after stomping on it for a while (at that point I did not care if I broke it into a million pieces lol), it finally worked. I didn't catch the scale size because I immediately reprinted at 76.04% (the next two). I do not recommend going smaller than 76%. It works great; Took a bit of time to remove the supports but it wasn't nearly as difficult to squish. My kids love them. Each print used nearly half the roll of filament, but super cool!
The designer has replied
0
Reply
The problem I found when making my mini version is that if I just scale it down the clearances can’t be printed well by the printer so that’s why I had to remodel it for the a1 mini.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Oh my gosh this took so long and so much, but was worth it. Some small errors where the supports were, but it works and is amazing
0
Reply
How is that possible? It is not multicolor and more than a kilogram
0
Reply
when the spool is empty replace it if you dont have an ams that autoswitch
0
Reply
Replying to @user_3387090190 :
It should pause at the place with no issues
0
Reply
His confusion is in how it uses so much filament for a model that doesn't look that big.
1
Reply
this is great except for the amount of filament
2
Reply
Boosted
Amazing; had to press really hard to get it to open, but after that it works flawlessly and noiselessly.
0
Reply
it works and it cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply