A simple frame is used to elevate the top glass of the X1/P1 16mm to provide more space for the PTFE tubes. Fitted with a magnetic, detachable door that can be quickly opened to enhance heat evacuation.

ABS is recommended for printing, also the frame looks like it has a lot of holes in it, don't worry they are not through holes. This is to release stress during the printing process and prevent bending, they also have little to no effect on strength.

You will also need to prepare 16 pieces of D8*3 magnets which can be glued into the holes on the side. If you can find magnets with holes in the middle, you can just fix them with some m2.5 screws. And of course you'll need some foam for cushioning and sealing.

Once you've assembled it, the door should be able to be easily removed and installed. For the very front of the glass, because the X1 has a handle on the glass, you need to use a door without a handle. Of course you can also just remove the handle on the glass because you may not have to lift the glass anymore.