Garden Slug Trap by Jon

Jon

Household>Garden

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.9 h

1 plate

4.8(4)

Boost

Released

Description

Hello everyon! this is a simple print of a slug trap. Slugs are a nuisance to any gardener, so this is the perfect tool to fight against those slugs! Simply bury the bottom section up to the brim in your garden so that slugs will crawl in, fill will beer as slugs are attracted to yeast! The slugs will drown and will not be coming back out. The lid comes off easily to check your traps, or refill with beer! Thanks everyone! Enjoy! Remixes welcome!

Comment & Rating (8)

@Stealth8301

Print Profile

0.2mm layer, 2 walls, 15% infill

I like the model design but I did change the print profile from 0.2 standard to 0.2 strength because I thought it might hold up better to being outside (only time will tell). I also didn’t use supports I didn’t think they were necessary and the print came out fine. I thought the normal supports that were enabled would have been a pain to remove, if I had chosen to use supports personally I would have picked tree. Thanks for sharing.