Print Profile(2)
0.28mm layer extra draft, 2 walls, 100% infill
Designer
50 min
1 plate
0.24mm layer Petg, 5 walls, 15% infill
1.4 h
1 plate
Boost
41
89
18
8
146
125
Released
Description
Save your plants for snails and slugs!
This ring is much stronger than most bought on Amazon, but still thin enough that you can print it for about 1 euro (less than 40g of filament).
There is a minor reinforcement at the part that you put in the ground, it will not bend excessively.
You can print it with an A1mini or bigger. I tested it on an A1 mini and X1C.
For best longevity, print with PETG or other outdoor suitable filament. Alternatively, use PLA (it prints faster, in about 40 minutes), but PLA will degrade faster in the sun.
You can print this in the fastest draft setting.
Comment & Rating (18)
All
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
Invasion abgewehrt :-D
0
Reply
Boosted
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
Works great while using only few Grams of Filament.
0
Reply
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
That's a good idea. I'll see if it keeps the snails away.
0
Reply
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
works and prints great
0
Reply
Boosted
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
Ras pour le moment
0
Reply
Boosted
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
0
Reply
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
Habe 2 gedruckt. Machen einen guten Eindruck. Da der Salat und die Kohlrabi schon weggefressen sind, steht die Bewährung noch aus. Bin aber sehr zuversichtlich.
2
Reply
What is the inner diameter ?
The designer has replied
0
Reply
It's 10cm at the part that goes into the ground, and 14cm at the top (also measured on the inside). In Bambu Studio, you can scale it to the size that you need.
1
Reply
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
perfekt
0
Reply
Print Profile
0.28mm layer extra draft, 2 walls, 100% infill
good product
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld