X1C P1 Tool & Accessory Tray - Top Mounted Storage

X1C P1 Tool & Accessory Tray - Top Mounted Storage

Boost
17
29
0

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

X1C - 0.2mm layer, 3 walls, 20% infill
X1C - 0.2mm layer, 3 walls, 20% infill
Designer
17.2 h
1 plate

Boost
17
29
0
0
21
5
Released

Description

X1C Tool Tray - Top Mounted.

 

I needed a custom tool tray for my X1C so I opened up MS 3D Builder and hacked this one together. I am quite happy with how it came out and it fits great. I am not a pro 3D modeler so any minor flaws should be considered indicative of the artisanal nature of the creation… :P

 

There is an integrated scraper sleeve that fits low profile scrapers. I use my Ninja Scraper and it fits perfectly.

 

Ninja Scraper: https://makerworld.com/en/models/472407#profileId-382223

 

Perfect slots for flush cutters, needle nose pliers, build plate glues, and even a handy dandy phone stand so you can read the wiki while you are tinkering with the printer.

 

These are the flush cutter I use that fit perfectly:

https://www.amazon.com/HongWay-Cutters-Cutting-Electronics-5-inches/dp/B09W8YYJD6

 

These are the needle nose plier I use that fit perfectly:

https://www.amazon.com/gp/product/B002KS96SW

 

I added small rubber feet from Amazon which makes it not slide around or scuff up the printer.

https://www.amazon.com/gp/product/B087MG3G76

 

Printed it good ol PLA. Glue the two keyed halves together with the CA of your choice. I like Loctite Ultra Gel Control.

 

I use the High Temp plate with Dimafix and warping is simply not possible.

 

Enjoy!

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more