Me auto percibo Pared / I Percive my self as Wall

Me auto percibo Pared / I Percive my self as Wall

Boost
2
0
0
This model is created by Make My Sign
Make Your Model

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.28mm layer, 2 walls, 15% infill
0.28mm layer, 2 walls, 15% infill
Designer
3 h
1 plate

Boost
2
0
0
0
2
0
Released

Description

ENGLISH:

Humorous Sign/poster for businesses where the access door is double and the customer always tries to open the wrong one.

 

Available in Spanish and English, with the arrows in both directions (be sure to print the corresponding one), in the name of the STL and 3mf file the door on which the sign is to be placed is placed, therefore “MeAutoPerciboPuertaDcha .stl/3mf” and “MeAutoPerciboPuertaRight.stl/3mf” are the ones that must be placed on the right door, since the arrow points to the left and the other two on the left door since the arrow points to the left. the right.

 

Printing instructions:

 

Layer height: 0.28

Top and bottom layers: 6-5

Walls: 2

Infill: 15% gyroid but in this case, the lower and upper layers make the piece solid and 100%

no supports needed

Weight: 136 grams including purges

Material: In this case they have been printed in PLA because the door where they are going to be placed hardly receives any sun. If it were to be placed in a place where it gets a lot of sun, it is advisable to change to ASA

Printing time with Bambu x1: 2 hours 58 minutes

----------------------------------------------------------------------------------------------------------------

ESPAÑOL:

 

Cartel humorístico para negocios donde la puerta de acceso es doble y el cliente siempre intenta abrir la que no es.

 

Disponible en Español e Inglés, con las flechas en los dos sentidos (asegúrese bien de imprimir la que corresponde), en el nombre del archivo STL y 3mf se pone la puerta en la que se ha de colocar el cartel, por lo tanto “MeAutoPerciboPuertaDcha.stl/3mf” y “MeAutoPerciboPuertaRight.stl/3mf” son las que han de colocarse en la puerta de la derecha, ya que la flecha señala a la izquierda y las otras dos en la puerta de la izquierda ya que la flecha señala a la derecha.

 

Instrucciones de impresión:

 

Altura de capa: 0,28

Capas superior e inferior: 6-5

Paredes: 2

Relleno: 15% giroide pero en este caso, las capas inferiores y superiores hacen que la pieza sea maciza y este al 100%

no necesita soportes

Peso: 136 gramos incluyendo las purgas

Material: En este caso se han impreso en PLA porque la puerta en la que se van a poner, apenas recibe sol, si se fuera a poner en un local donde le de el sol mucho, recomendable cambiar a ASA

Tiempo de impresión con Bambu x1: 2 horas 58 minutos

 

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more