The planet Jupiter from a photo, created with HueForge. I hope you like it!!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used was all Kingroon PLA+:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Generic Black Transmission Distance: 0.2
PLA Generic Red Transmission Distance: 4
PLA Generic Orange Transmission Distance: 5
PLA Generic Yellow Transmission Distance: 6

Swap Instructions (should also be part of 3mf):
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #12 (1.04mm) swap to Orange
At layer #18 (1.52mm) swap to Yellow for the rest.