Collapsible dice tower
Copyright Claim
Collapsible dice tower
Boost
154
266
61
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
16.6 h
2 plates
Eliminates the gap when folded! 0.2mm layer, 2 walls, 15% infill
Designer
50 min
1 plate
NoGap Archimedian @ 0.16mm Optimal for P1S
8.9 h
1 plate
Boost
154
266
61
5
437
358
Released
Description
There are two trays, one with windows and one without!
Comment & Rating (61)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I love this. Simply gorgeous. A little tricky to assemble, but very well designed. Thanks so much for sharing this design.
The designer has replied
0
Reply
what filament did you print with? :)
0
Reply
Replying to @Poli27
Sunlu PLA+ Silk Rainbow
0
Reply
Replying to @Poli27
Sunlu PLA+ Rainbow Silk
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Enabled support generation :)
0
Reply
Replying to @Poli27
does it require support?
0
Reply
Replying to @vietfarmer21
yes 3mf file to automatic config to support :)
0
Reply
Boosted
Printed great, though tweaked some settings to get a nicer finish inside the rolling tray and because I can't leave well enough alone. Printed this same model years ago in resin and always hated that little gap, so thanks for fixing this OP!
0
Reply
Great design idea! Slicer thought the top piece needed support, so added that in, printed great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Superb!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
came out awesome! thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome model
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It's not the best rolling tower. Sometimes the dice stop just inside the door. But it's awesome otherwise. I love how the dice tray fits over the collapsed assembly like a cap. I used Amolen Silk PLA, Blue/Red gradient. bumped the hot end up 10° and the build plate up 5°(230/40). printed great with auto support.
0
Reply
Could you hide the split between the bottom piece and the upside-down courtyard? I don't have the knowledge to do it myself, yet.
The designer has replied
0
Reply
what do you think exactly?
0
Reply
Replying to @Poli27
There are a few millimeters between the walls. Main brain would be happier without that.
0
Reply
Replying to @samuel.joost
I'll check it out when I have time :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Looks great! May I ask for details about the filament you have used for printing this? Thank you in advance.
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld