Bambu lab PTFE-Bracket NEW VERSION Tube horizontal
Remixed by
Copyright Claim
Bambu lab PTFE-Bracket NEW VERSION Tube horizontal
Remixed by
Boost
5
21
12
Print Profile(2)
PLA-0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
PETG-0.2mm layer, 6 walls, 100% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
5
21
12
2
47
48
Released
Description
Bambu lab PTFE-Bracket NEW VERSION Tube horizontal
Ich habe das Modell nur minimal verändern müssen da es schon sehr gut war
ich habe aber 6 Wände und 100% Füllung gemacht damit es sehr stabil ist
druckzeit dadurch minimal länger aber dafür auch massiv und stabil.
PTFE Tube kommt oben gerade raus und schleift somit nicht mehr am Glas
Comment & Rating (12)
All
Printed with PLA used on P1S， used it for 2 days before it got deformed and started to contact with the front of the printer when homing and purging.
The designer has replied
1
Reply
ok
am besten für solche Teile immer mindestens PETG nehmen noch besser ABS oder ASA
0
Reply
Print Profile
PLA-0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PLA-0.2mm layer, 2 walls, 15% infill
very good
The designer has replied
1
Reply
thanks
0
Reply
Print Profile
PETG-0.2mm layer, 6 walls, 100% infill
I printed 3 different kinds of these guides before settling on one I like best. this one has a hard bend, and the rounded edge versions help the tube conform better to something. this one is also a bit long, may collide with chain at the front corners.
The designer has replied
1
Reply
danke für die Info....das mit der Kette berühren werde ich mir mal ansehen
0
Reply
Print Profile
PLA-0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thanks
0
Reply
Boosted
Print Profile
PLA-0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
thanks
0
Reply
Print Profile
PETG-0.2mm layer, 6 walls, 100% infill
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld