Mini Watering can by despacho3d

despacho3d

Household>Garden

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

46 min

1 plate

4.7(6)

Boost

Released

Description

Mini watering can.

In principle it is not necessary to use supports, for a correct finish of the overhangs, I recommend fine-tuning the calibration of the filament.

I have printed with an A1mini.

Enjoy printing.

Comment & Rating (14)

@hollowmaker

Print Profile

0.2mm layer, 2 walls, 15% infill

Reprinted it. Now its perfect! It was my fault. Thank you! 😊

(Edited)

The designer has replied

@despacho3d

Hello! I'm sorry, in my case it has not been like that, the overhangs have turned out well, I like to finely calibrate the filaments, it is true that the upper bridge is somewhat more complicated. Thanks for your comment.

(Edited)

@hollowmaker

Replying to @despacho3d :

Hi, Thank you for the response. I will print the model again with a different filament.

@Disttrack3D

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect profile, perfect printables overhangs without supports and cool model!

The designer has replied

@despacho3d

Nice print!!! Thanks!

@user_3654435933

Print Profile

0.2mm layer, 2 walls, 15% infill

the handle printed badly. when slightly tilted the water goes back instead of forward other than that's, its good

The designer has replied

@despacho3d

@SaltyPsych

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed with zero issues. Holds the perfect amount of water for my granddaughter to “water the plants” with causing and damage to the house.

The designer has replied

@despacho3d

Jejejejeje, Nice!!!!! Thankssss!!!

@SaltyPsych

Printed perfectly. Holds the perfect amount of water for my granddaughter to “water the plants” and not to do any real damage around the house. printed on A1 using Overture basic red.