This is a picture of the Hungarian parliament building taken from the river in Budapest on my honeymoon. This picture lends itself to looking awesome in Hueforge. Note this one is pretty thin, so take care in taking it off the bed!

Fyrby Additive holds a commercial Hueforge license.

Colours

I used the following colours in this print, but any black, white, yellow and orange will probably work:

• PLA BambuLab Basic Black
• PLA BambuLab Basic Yellow
• PLA BambuLab Basic Orange
• PLA BambuLab Basic Jade White

Printing

Please note the slicer will give you a warning about floating regions. It is safe to ignore this.

There is a pre-configured profile for Bambu studio available as well as the separate STL if you want to do it manually. This Hueforge is setup to use a 0.2mm nozzle and expects a 0.1mm bottom layer and a 0.08mm layer height with 100% infill and 1 wall. The Hueforge Describe follows:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.1mm

The Model is 152x113.98mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #6 (0.5mm) swap to Orange
At layer #9 (0.74mm) swap to Yellow
At layer #10 (0.82mm) swap to Orange
At layer #12 (0.98mm) swap to Jade White
At layer #13 (1.06mm) swap to Orange
At layer #15 (1.22mm) swap to Yellow
At layer #19 (1.54mm) swap to Jade White for the rest.