Segway Navimow Antenna wall mount
Segway Navimow Antenna wall mount
Boost
7
6
5
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
2.6 h
2 plates
Boost
7
6
5
2
31
24
Released
Description
Simple 90 degree angle mount for the Segway Navimow i105e/i108e antenna.
Designed to be printet without supports.
Really sturdy with these print settings:
- 0,2mm layer height
- 3 walls
- 5 top and bottom layers
- 25% grid or gyroid infill
If you are using the model with 2 holes, the bottom one can be a bit tricky to screw in, pre-drilling the holes helps a lot.
Comment & Rating (5)
All
You forgot to upload the model with one hole. Otherwise - GREAT design (I haven't even printed it but I'm sure it'll be perfect!) Thank you!
(Edited)The designer has replied
0
Reply
Thank you for the feedback - glad you like it. I have updated the print profile to contain both version on separates plates.
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld