Table Saw Enclosure Kit
Table Saw Enclosure Kit
Print Profile(1)
Description
This kit is to enclose the hole around the height adjustment wheel of your table saw. It restricts some of the air flow to allow for better suction of your dust collector. It directs the air movement up to the blade, and also stops saw dust from flying out the front end at your legs.
This model includes 3 different pieces…
- Leader: This piece goes directly to the left of the height adjustment wheel on your table saw
- Follower: This piece goes directly to the left of the height-adjustment wheel
- Body: These pieces go either on the left or right side of the Leader/Follower to fill in the hole of the table saw.
If the table saw is set at 90 degrees (Height- adjustment wheel is all the way to the left), then you'll have the Leader on the left side of the wheel, followed by the Follower on the right side of the wheel, followed by the Bodies.
Each piece takes two 8x3mm magnets (10 total) that can be glued in place. 5/16" x 1/8 " magnets will also fit, but these will need to be pushed in with pliers for a very tight friction fit.
See video below for instructions on how to use…
Comment & Rating (2)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
