Fallout T45D Power Helmet - A1 Mini Friendly
Remixed by
Copyright Claim
Fallout T45D Power Helmet - A1 Mini Friendly
Remixed by
Boost
22
21
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.6 h
1 plate
Open in Bambu Studio
Boost
22
21
10
3
37
18
Released
Description
Fallout T45d Power Armor Helmet
based off of the one in Fallout 3 and New Vegas.
Many parts weren't fixed to the helmet so I had to remove/regroup and reput :)
The top left light and belt is floating but attached to the helmet - looks better in my opinion - just pay attention when removing the supports for there.
Image is dropped in Bambu Slicer and rotated to allow less neck and the rear breathing tubes to rest on the plate.
Nice single colour print that is A1 mini friendly but would look just as good upscaled and coloured for an X1C.
Enjoy!
"Fallout: T45d Power Armor Helmet" by Cryostatic is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
love it. yes sport suck to takeoff you need them, though. I broke one IP as you can see on the white one so I snipped it back so it doesn’t even look like it was ever printed and then I did the black one for buddies of mine. I’m not sure which one I like better, the other helmet, the T 51. I’m gonna try the 51 now. I think with the T5 one I’m gonna make it bigger and use a .6 nozzle cut the print time down. See how it goes. Great job. Keep up the work.
The designer has replied
0
Reply
yep they do suck! i could never get this fine pipe for the life of me to stay on so used some PLA - they look good - would be interested to see a larger one on .6 - drop the infill down and shoot a photo if you do it. Thanks for the boost too! :)
0
Reply
Replying to @brentglover1970
Enlarged it quite a bit. The biggest thing is that front mask vent didn’t come out really good and I had some overhang issues due to me being impatient and speeding it up at the end instead of just letting him go slow, but I did the honeycomb at 10% and six nozzle.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
really great design. use alot of caution when removing the supports
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Tolles Ding
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed very well in Kingroon PLA+ for a coworker.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
© 2024 MakerWorld