blackwindowc

0.2mm layer, 2 walls, 15% infill

mindlessgreen

cover

IMG20240425000554_1_5549a4a5-f01f-4f87-97fc-48bad62fdf47.webp

plate_1.png

Example of my poor quality print. Do not use this profile for print.

IMG20240426000717_1_60e4c2d6-ca7a-42e5-a265-f4ae6061be30.webp

IMG20240426000752_1_ae2f73a7-b588-48c6-af91-d77607853bb8.webp

Pressure advance (K) = 0.04Flow rate = 0.94Filament: Clas Ohlson (FlashForge) PETGSeam: BackOuter wall: 70Inner wall: 120

20240425_131524_9bb11e19-48bc-4e7e-83f5-ab4efb7ad320.webp

20240425_131546_8bededae-c105-43d7-ac59-2bb2c3803f71.webp

20240425_132544_8202af03-d18f-439c-96e9-a595b222a36b.webp

20240425_132602_1ad2c397-128f-455f-8701-c6f072eaef86.webp

vladimir.minkov

PETG profile using eSUN PETG , should be a good base for most PETGs FLOW and K may bary&nbsp;Note that custom M900 K0.038; &nbsp;from the filament settings command was removed by the makerworld&nbsp;&nbsp;Best Results probably with &nbsp;K= 0.042 and temp 255 instead of 260 but the above one is pretty good&nbsp;&nbsp;On the photos the left one is with under extrusion and too high K , the right model is with this profile&nbsp;&nbsp;

20240425_132544_41c90f25-dfe0-4c5a-80a2-a7f1d4c5f6eb.webp

This is example ASA relatively fast or the fastest which works for me with out issues&nbsp;note the i use only manual PA(K) and for Bambu &nbsp;slicer needs the command in the filament advance settings:&nbsp;M900 K[pressure_advance] L1000 M10; BS transfer test based on Orca slicer outputor if Filament profile generated from Orca Slicer and used in Bambu slicer&nbsp;or hard coded:&nbsp;M900 K0.047 L1000 M10; BS transfer test based on Orca slicer output&nbsp;But Maker worlds strips this command&nbsp;The slow profile is the same just reduce most of the speeds to 70mm/S and acceleration from 7000 to 4000 , 3500 to 2000&nbsp;Note the overhangs speeds on this profiles has ben modified for default but also default are working quite well&nbsp;Ignore the photo as is the wrong one&nbsp;&nbsp;and for got sake do not ask me for problems on this settings if you have not dried and tuned the flow and manual PA/K - the Bambu autoflow(PA/K) does not work &nbsp;well enough and do not care .&nbsp;

X1C ASA relatively fast 0.2mm layer, 2 walls, 15% infill

Test print for hexagonal hole on side face

Print Profile(4)

Description

Comment & Rating (1)

License

Related Models

(20mm) MFT Bench Hole Chamfer Tool

Parametric bits box with hinge, lock and magnets

Translucent test model

Hex-Gyroid Fidget Toy

Hex hole test