Varying sized clamps for using has hold downs on CNC table.
I find it best print them lying down on the side, support is needed.
Generated Clamps
Resources
OpenSCAD/Customiser settings
The clamps are generated using an OpenSCAD model, you can use the built in customiser . The model is included in the supplied files.
CNC hold down
Setting | Description |
---|---|
Bolt_Cutout_Length | Length of bolt cutout (mm) |
Bolt_Cutout_Diameter | Diameter Length of bolt cutout (mm) |
Bolt_Clearance | Clearance around the bolt head (mm), default = Bolt_Cutout_Diamater |
Wall_Thickness | Thickness of the front and side walls (mm) |
Base_Thickness | Thickness of the base(mm), Default = Wall_Thickness*2 |
Base_Relief | Back relief on base (mm), default = Wall_Thickness/2 |
Setting | Description |
---|---|
Front_Radius | Radius of front lip (mm), default = Wall_Thickness |
Front_Lip_Length | Length of front lip (mm), default = Front_Radius |
Front_Height | Height of front lip (mm), default = Front_Radius |
Front_Relief_Angle | Relief on front (deg) |
Front_Wall_Thickness | Front wall thickness (mm), default = Wall_Thickness |
Support_Length | The full height length (mm), default = half length |
Support_Height | The full Length height (mm) , default = quarter height |
Setting | Description |
---|---|
Back_Radius | Radius of back lip, default = Base_Thickness*3/4 |
Back_Lip_Length | Extend length of back lip |