A simple dart holder for Nerf N-Strike darts (also holds most other darts of similar size). This will hold 24 darts and is easy to load and unload. Keeps darts together and off of the floor.

Different printers can leave more or less overlap within the holes. I recommend sanding the holes slightly in order to prevent plastic burrs from damaging darts. Darts should fit snugly so holder can be moved around without darts falling out.

Print Settings

• Rafts:

No

• Supports:

No

• Resolution:

0.20mm

• Infill:

20%

• Notes:

These are the values I used to print. The angle is slight enough that no supports are needed.

Post-Printing

Different printers can leave more or less overlap within the holes. I recommend sanding the holes slightly in order to prevent plastic burrs from damaging darts.