No springs needed! 

A Glock19 based half-length nerf dart shooter with magazine. Requires only 2 rubber band and 2 optional m4x30 screws(if you don't have  screws, you can use glue to do the same thing.) to build.

It is compatible with WORKER angled talon magazine*.(I recommend using it instead of using the printed magazine in source file from the perspective of performance and staibility. You may also require two extra m4 screw to build the printed magazine)

Printing metarial: PLA Basic

Install method:

1. install trigger into the body 
2. install gear part to the body (use 2 m4 screws to secure it)
3. install slide part to the gear (slide's left side first, you probabaly need to bend the slide a little bit)
4. put the “|-|” shape part into the shooter and install the rubber band 

*6/26 Update:

    Recommend using 10-darts angled talon magazine. 

    For both printed magazine, I recommend load only 7 darts per magazine for best stability and performance.

    If you want use talon magazine with more than 10 darts or reduce the possibility of jam, please lubricate this part（using WD40 or something similar）:

无需弹簧！基于格洛克19设计的弹匣式短软弹发射器，只需要2个橡皮筋+可选的2个m4螺丝即可制作！（如果没有螺丝的话可以用快干胶固定）

兼容工匠斜龙爪弹匣*，也推荐使用此弹匣，相比于本模型自带的3D打印弹匣要更稳定。

打印材料：PLA Basic

安装方法：

将Accessory盘的扳机零件安装到机身。
将Gear盘部件（也就是“机匣”，我这儿就先这么叫了）安装到机身上（使用2个M4螺丝固定）。
将套筒（Slide盘）部件安装到机匣上（先把套筒的左侧扣进去，可能需要稍微弯曲下套筒）。
将杠铃一样“|-|”形状的部放进发射器里（见封面里的放法），并安装橡皮筋即可。

*6/26更新：

推荐10发版斜龙爪弹匣

3D打印弹夹最好只装7发软弹，以保证最佳的稳定性和性能。

如果你想使用大于10发的斜龙爪弹匣，或者想减少卡弹概率，请用润滑油润滑下面区域：

Reference model modification list:

Glock 19 v6 movable trigger and slide: dig serveral holes on the model and carved some place to allow shooter mechanization to fit.

Printable Angled Taloon Magazine: used its 10 round version parts and modified its rear part's top(add a clip to make it attachable to the shooter)

Simple printed taloon mag: used its spring part to make the magazine

Picatinny Rail: attached it to the shooter body to make the shooter more tactical

BerettaM9: Used its trigger parts as the gun's trigger