XXL X1C/P1S Filament "Poop" Chute - Screw Mounted
Copyright Claim
XXL X1C/P1S Filament "Poop" Chute - Screw Mounted
Boost
71
112
37
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
5.1 h
1 plate
Boost
71
112
37
14
272
231
Released
Description
XXL-Version
I have only a few centimeters/inches behind my X1C-printer available. As a result, I designed a filament “poop” bucket with smaller dimensions. This bucket can be mounted via the shipping screws.
For larger prints with a fair amount of filament changes, more volume is needed. This bucket ensures that.
A medium version can be found here.
An additional chute and deflector can be found here.
Bucket dimensions:
HxWxL: 160x60x160 (mm)
Screw hole: 3,5mm radius
Wall: 1,2mm
Filament needed:
35,25 meter
111,93 grams
Print time (X1C):
Prepare time: 7m56s
Model printing time: 4h59m
Total time: 5h7m
Comment & Rating (37)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
nice and well printed!!!
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
perfect fit
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Been working sweet for me. Thank you.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
turned out great! I added a couple of little magnets to compliment the fit.
never liked those poop shootz with a slide around the corner. thanks for the model 🙏🏽
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Erfüllt seinen Zweck. Tip Top. Vielen Dank.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Turned out great, nice and sturdy. Flat enough that you could affix it to the back of the printer with some double sided tape or a command strip. The stock screw is a tight fit, it would work best if you could find one that is a couple milimeters longer. It looks like near the top of the model a few of the layers have a slightly different radius at the outer edge that faces the printer but it doesn’t impact the strength of the part in any way and isn’t very noticable. Thank you for the model!
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
Ok!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printer perfectly
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
aucun soucis d’impression
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed well, and does the job nicely.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld