Poop Chute Adapter for Plastic Bag
Copyright Claim
Poop Chute Adapter for Plastic Bag
Boost
53
95
7
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
53
95
7
1
53
54
Released
Description
This unique purge chute solution screws right onto your P1- or X1-Series Bambu Lab printer and allows you to attach plastic bags to catch filament waste!
Steps:
- Wrap a plastic bag around the mouth of the Poop Chute Adapter and use a zip tie to fasten it securely.
- Unscrew the two small M3 screws above and below the purge chute.
- Align the Poop Chute Adapter and screw it on.
- Note: you may need to use slightly longer M3 screws than those you just removed. I used screws provided by Bambu Lab in the accessories box shipped with my printer!
- Note: The hole on the front side of the Poop Chute Adapter is there so that you can stick your hex key through it to tighten the bottom screw
- Now you're ready to print without filament poops landing everywhere!
Comment & Rating (7)
All
What would be nice is, an end of the adapter that a 2" pvc pipe fitting can attach to.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
cannot get a bag or zip tie around the end no clearance to housing
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld