laser material riser

Copyright Claim

laser material riser

Boost
5
8
3

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.16mm layer, 3 walls, 15% infill
0.16mm layer, 3 walls, 15% infill
Designer
3.5 h
1 plate
5.0(2)

Boost
5
8
3
1
15
4
Released

Description

I have designed an easy way to raise your material off the laser bed to prevent flash back from the honeycomb bed.

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

 

I designed this piece to hold a magnet I got from amazon for making a different print and had extras left over. It's a strong magnet and has a really good grip on the honeycomb bed of my laser.

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

 

You will need to order these magnets from amazon, or one with the same dimensions in order to fit the hollow space I put in the middle of of the bottom attachment: Cup Magnets, 95lbs Holding Force 1.26 inch D x 0.2 inch H, 12pcs Super Power Round Base Magnets Neodymium Rare Earth Magnets with Countersunk Hole, Screws for Home Workplace, Kitchen

 

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.16mm layer, 3 walls, 15% infill
The designer has replied
1
Reply
thank you for the rating.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
No more