10mm focal height material riser

Remixed by
Copyright Claim

10mm focal height material riser

Remixed by
Boost
1
4
2

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.16mm layer, 5 walls, 25% infill
0.16mm layer, 5 walls, 25% infill
Designer
1.5 h
1 plate
5.0(1)

Boost
1
4
2
0
6
3
Released

Description

This is for a laser that has a 10mm focal distance or more

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

 

I designed this piece to hold a magnet I got from amazon for making a different print and had extras left over. It's a strong magnet and has a really good grip on the honeycomb bed of my laser.

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

 

You will need to order these magnets from amazon, or one with the same dimensions in order to fit the hollow space I put in the middle of of the bottom attachment: Cup Magnets, 95lbs Holding Force 1.26 inch D x 0.2 inch H, 12pcs Super Power Round Base Magnets Neodymium Rare Earth Magnets with Countersunk Hole, Screws for Home Workplace, Kitchen

 

 

***AFTER SLICING/BEFORE PRINTING: you will need to find the layer that is the last one before the void in the base is covered and put a pause in the printing G-code. Failure to do this will cause you to not be able to install the magnet.***

 

The third piece is a support for the center of the material being held. It is the same height as the magnetized base.

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 5 walls, 25% infill
0
Reply
Thank you for the rating. Hope they work well for you.
0
Reply
No more