got one of the mini lathes 7x14 from vevor on amazon an loving it so far but i didnt have much room to work with so i start looking for ways to organize the tools an cutting tools that i got for it so far an most of what ive tried downloading dont fit what i have so i took what i found an liked an remixed the ones that fit my lathe to hole the tools i have an i made up a bunch of different counts for the cutting tools that way u could mix an match them to how many you have so u dont have empty slots in the tool holder an u can add to them as u get more. the allen wrench holder i made to hold all that came with the lathe and the quick change tool post but it didnt come with a 10mm allen wrench an that is what holds the quick change tool post on so i may end up updating the allen wrench holder later on once i work out what all is needed for my setup. also there's a 3 jaw chuck key holder, not sure if they are different from a 4 jaw cause i havent gotten one yet an this is my first lathe an the only one ive ever used so i may add more as time goes on.