LA Kings - Thor's Hammer

This is a Kings themed Thor's hammer. It is separated into three plates so that it can be printed easily. I think after many tests and small alterations, I have come up with a really good profile for this. I sacrificed a little bit of time to get a more durable, better quality result that can be handled fairly rough, haha.

Credits:

@ChaosCoreTech (Original Hammer Designer) - https://www.thingiverse.com/thing:1311108
@Emp3thy (Hammer Remix) - https://makerworld.com/en/models/44616?from=search#profileId-46284

@Burnnoticed (Remix /w NFL Branding) - https://makerworld.com/en/models/166035?from=search#profileId-182300

@3DHummel (Rock Stand - 75%) - https://www.printables.com/model/132359-thors-hammer-molnjir-life-size-with-better-handle-

Changes:

My remix fixes quite a few issues I had with the original NFL hammers.

• I was able to get rid of the slight line that ran down the middle when printed.
• 
• No more removing a mess of supports from the inside.
• 
• The handle has been changed/re-oriented. This uses a bit more supports, but it provides a clean connection to the bottom of the hammer. I have printed lots of these for friends and family, and we had a few break off at that point. This change seems to end up with a sturdier hammer.
• 
• The “top cap” has had the lettering removed. At 75%, the quality suffered, and this just provides a cleaner look, especially with a textured plate.
• I replaced the bottom cap with a different design, that sits flush with the side of the handle. This helps prevent the top pieces from snapping off.
• 

Upcoming

Currently in test print. The original model had some uneven areas for the handle to connect. This caused it to not sit flush with the bottom, I have fixed that and will update the model once it is tested.