Burning MatchStick Shooter - FireArrow by uhltimate

uhltimate

Education>Engineering

GIF

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.16mm layer, 2 walls, 15% infill

Designer

2.2 h

2 plates

4.6(40)

Strength Profile, 0.2mm layer, 6 walls, 25% gyroid infill

2.7 h

2 plates

4.5(11)

A1 mini, 0.16mm layer, 2 walls, 15% infill

2.5 h

2 plates

4.0(12)

Open in Bambu Studio

Boost

450

821

723

523

Released

Description

— Handle With Care ---

Introduction:

Discover the thrill of launching matches with precision using my innovative 3D printed matchstick shooter. Crafted for safety and excitement, this print-in-place model guarantees endless fun for responsible users.

Print settings and assembly are shown in my YouTube video here:

Disclaimer:

While my matchstick shooter offers thrilling entertainment, it's important to note that igniting matches carries inherent risks and should be handled responsibly. This product is intended for adult use or under the supervision of responsible adults. Operate it in a controlled environment away from flammable materials, and always exercise caution to prevent accidents or fires.

Comment & Rating (76)

@TheNerdyOne

Print Profile

0.16mm layer, 2 walls, 15% infill

Cool beans

(Edited)

@tattertotman

Boosted

Print Profile

Strength Profile, 0.2mm layer, 6 walls, 25% gyroid infill

I was very excited to print this and try it out. When the match struck and shot out it was super fun to see, but I did experience some issues with the matches getting stuck. And unfortunately I got a small burn on my finger from the underside but I am going to improve the design by adding some aluminum tape on the underside to effectively work as a heat shield to prevent accidental burns. I will also add some more striker paper to increase strike power.