Roller Dice V2

All Printed at .2mm layer height.

*****Supports needed for printing the rollers and the main housing*****. These are personal preference so you select which you would prefer. Had to add this text as some folks expect you to hand feed them

Hardware needed:

• Quantity 1 - M3 x 16 screw.
• Quantity 4 type 608 skateboard bearings.
• Quantity 16 -18 - 3mm diameter x 2mm length magnets. (updated due to the original spec no longer available)
  • (All items available from Amazon). 
  • I took the covers off the bearings, cleaned the grease out and added a little oil, just so the bearings rotated more freely.

Assembly:

1. Insert 12 of the magnets into the 2 rollers and 2 each into the main housing and cover (for less spinning use 3) ***IMPORTANT*** ensure you have the polarity correct. I would recommend only inserting the magnets half way so if you do mess it up, you can get the magnets out again. ***Due to tolerance stack ups and material differences, you may have to use a spot of glue to hold the magnets or bearings as all materials may differ in results***
2. Insert the shaft into the main body
3. Install 1 of the spacer onto the shaft
4. Install your first roller
5. Install a second spacer
6. Install the second roller
7. Install the remaining spacer
8. Fit the main body end piece onto the locating pins
9. Screw in the M3 screw, DO NOT OVER TIGHTEN

Please like and upload a picture of your prints.

If you like this print and would like to donate a boost, that would be much appreciated.

Happy Printing