Self watering herb/flower pot by EPIQ3D

EPIQ3D

Household>Decor

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

2.2 h

1 plate

4.8(33)

0.2mm layer, 2 walls, 15% infill

2.6 h

1 plate

5.0(2)

Boost

143

246

443

253

Released

Description

Make All your herbs easy in the kitchen.

This planter ensures that your herbs stay fresh and hydrated.

HOW IT WORKS

The self watering planter is designed to slowly absorb water from the reservoir (This needs to be filled up occasionally).

Its a one piece print (uni body).

The water inlet, is alongside the upper part, and is guided down to the reservoir.

This also acts like a overflow, so you dont overfill the reservoir.

(Stop filling in water, when is reaches the edge, or when it pours over - you decide)

It is recommended to use a wicking material at the center (between the soil and the water).

This helps to absorb water into the soil slowly. You can place a couple of cotton balls / cotton wool in the bottom of the pot.

I recommend filling wicking material so it is above the reservoir edge, then fill with soil, and your herb of choice.

Basic print settings:

Infill : 10%
Walls: 3
Top/bottom shell layers: 3
No support needed

Dimensions: hight 70mm, Crossection: 74mm (at the widest point)

Comment & Rating (39)

@FOXTWO

漂亮的花瓶！

@Topik

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed in red PETG, scaled to 200%, used 3 walls just to be sure, no water leaks. Thank you 🙂

@BOFH1337

Print Profile

0.2mm layer, 2 walls, 15% infill

love it! My kid confiscated the pot because it’s so cute :)

@3Devil

Print Profile

0.2mm layer, 2 walls, 15% infill

very good, thx for this model

@user_1638383390

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice print, just a bit small. Next time I'll scale it up.

@Renard.pecheur1

Print Profile

0.2mm layer, 2 walls, 15% infill

like the results. was supposed to bring at the office but find it too nice. used banbu lab tought pla

@Jokeefe9351

Print Profile

0.2mm layer, 2 walls, 15% infill

looks great on my work desk

@retnuh

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

@chefalexander73

Print Profile

0.2mm layer, 2 walls, 15% infill

I printed it twice in petg blue first print was my mistake too small Second print on my A1 mini the middle part is too thick it doesnt give enough clearance to the water to go down it's too narrow. I am new at printing, I am learning but I think the design could be better. Skinnier just like the other planter version. Marie

(Edited)

The designer has replied

@PiTRiS

Boosted

Look at description from designer - use some cotton to put it in the tunnel, it will get the water to soil :)