Badger badger badger badger badger badger badger badger badger badger badger badger MUSHROOM MUSHROOM!

Measures approx. 100mm x 100mm.

The included 3MF file will have the colour swaps already set up. Alternatively, use the STL and set up your own filament swaps and settings as per the instructions below.

If you need to resize this print, change only X and Y dimensions. Altering the Z height will mess up the layer colour swaps.

Unlike typical HueForge prints, this uses relatively thick layer heights. You will need a low TD white for it to work - I used eSun's Cold White with great success.

Print at 100% infill with a layer height of 0.24mm with a base layer of 0.24mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Grey Transmission Distance: 3.5
PLA BambuLab Basic Brown Transmission Distance: 2
PLA+ Esun Cold White Transmission Distance: 2

 

Swap Instructions:
Start with Black
At layer #6 (1.44mm) swap to Blue Grey
At layer #7 (1.68mm) swap to Brown
At layer #8 (1.92mm) swap to Cold White for the rest.