Saw a lot of filament clips around but none that I liked after printing and trying them. The standard S clip versions are either to fiddly or to flimsy. The wrap around one's I also found to be OK for when you have a full spool but my fat hands do not work inside the spool so well so found these also to be a pain to use.

So I came up with a hybrid version which is a mix of both, and here it is.

I used PLA at .2mm layer height and no supports needed in the orientation I have them on the plate in this model.

Magnets I used are 3/16 x 1/16 and are super cheap from Amazon. Or shop around. One glue drop needed to hold them in place

Contact me for any questions. Please also like and rate this print