Universal Filament Clip Universal wire rack
Copyright Claim
Universal Filament Clip Universal wire rack
Boost
175
341
52
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
0.2mm layer, 2 walls, 15% infill, A1 mini
13 min
1 plate
Boost
175
341
52
7
472
398
Released
Description
There was no suitable wire clip, so I designed my own one. This wire clip is very convenient for clamping, installing, and removing：
Card installation with independently designed wire reel buckle
The wire buckle is also designed with a rebound structure
Removing the buckle also has a corresponding loosening area for shaking hands
In short, it is very convenient.
Comment & Rating (52)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
it was a little tight getting the filament in at first but I gently pried that part lose with a flat head screwdriver until it had enough play to let the filament snap into place.
The designer has replied
0
Reply
It's not inserted, it's pressed in. Just hold down the threads on both sides and press it in
0
Reply
Replying to @Ydou
Just press it down like this.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fast and easy
The designer has replied
0
Reply
ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Ok
The designer has replied
0
Reply
Just press it down like this.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good in itself but unfortunately my filament doesn't fit in
(Edited)
The designer has replied
0
Reply
Just press it down like this.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out perfcetly.
(Edited)
The designer has replied
0
Reply
thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, A1 mini
nice
0
Reply
thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, A1 mini
Works great 👍👍
It might help to reduce the inner part of the clip by a few mm for spools that are nearly full.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Filament Klemmung ist zu eng
The designer has replied
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
0
Reply
Why is it a 4-star rating? Is there anything bad about it?
0
Reply
Replying to @Ydou
no just missclicked^^
0
Reply
Replying to @dario.z
Thank you, I hope to receive more feedback to make the product better and provide everyone with a better experience.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
5 stars thank you this will help alot
The designer has replied
0
Reply
you're welcome
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld