Love these but hope they do not get stuck in the AMS.
They are a little thick and there is not much room in the slots.
Had a problem getting a roll stuck in the AMS but that was because an inside filament
clip.
First I removed this tag and the roll kept getting stuck, after removing the inside
clip it had no problems anymore.
But I would place the tag as close to the middle as you can so it has enough clearance.
Good tip. I haven’t had any issues with mine yet, but maybe an older revision of the AMS has less space?
When I have some time, maybe I can try seeing if there's any way I can make it thinner just in case.
I don't know how much I will be able to change.
I did not have any problem yet ether 😅 but just to be safe I placed them as far to the middle I can.
I would not bother to make them thinner, there is enough clearance.
I am only cautious because rolls can move a bit left to right, and if it’s more to the middle of the roll it has more clearance 😁and my luck it wil get stuck on something stupid 😂😅