SUPER AMS Lite compatible desiccant cell
Copyright Claim
SUPER AMS Lite compatible desiccant cell
Boost
2
10
3
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, No Supports
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
2
10
3
0
18
5
Released
Description
The model this is for: https://makerworld.com/en/models/188758#profileId-208077 Thank you @Supergrapher!
This is only for the longest side and to add to this I may make another container for the shorter side.
I reccomend you remove the slanted peice on your SUPER AMS Lite that helps to hold the silica packs in. For me it was a very easy removal given the container is already very thin. Use flush cutters to snip the sides that attach to the walls.
Lid is loose I reccomend using scotch tape to hold it in. May redesign for a locking system.
Holes in the lid are 1.1mm and can definitely be increased in size depending on the diameter of your dessicant.
Comment & Rating (3)
All
If you could design the size of the small box, I would greatly appreciate it
The designer has replied
0
Reply
It should be the exact same just cut in half. This is where I put my other desiccant packs from filament. Because of how small the desiccant cell already is you can't get past the other channel for the filament to go through on that side. Even if you had a cell over there it would be very small so I just opt to stuff my filament desiccant in there.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill, No Supports
printed out fine
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld