Rework of Bambulab P1P/P1S Chamber Temp Encloser for BBL-Magnet
Remixed by
Copyright Claim
Rework of Bambulab P1P/P1S Chamber Temp Encloser for BBL-Magnet
Remixed by
Boost
13
24
21
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
36 min
1 plate
Boost
13
24
21
0
78
79
Released
Description
A rework of “xperiments” “Bambulap P1P/P1S Chamber Temp Encloser” to fit the Magnet, that comes with ever BBL-Printer for the Scraper (and I know, no one glues it to the Scraper :P )
Pls like this model when you download it, and also the Original from “xperiments”!!!
He does a great Job in programming Software to make our life with P1S/P1P even better :D
Comment & Rating (21)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Fast print
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Needed to shave off some plastic in the slider as it was touching components on the card.
and remove some of the pins.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Had to print the little part twice due to piece broken on threads. New one is fine and installed, working without issues now.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Fitted fine 👍
1
Reply
Ausführung ist gut, doch leider lässt sich die Platine nicht einschieben, denn die Lötpunkte des Transistors und der Anschlussklemmen stehen unten mindestens um 1mm raus, somit kein Platz dafür.
Ach ja und der Magnetkleber des Schabers ist länger als die zu kurze Aussparung des Druckteils.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld