Low Profile AMS Riser For both X1 and P1 Models
Copyright Claim
Low Profile AMS Riser For both X1 and P1 Models
Boost
3
9
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Boost
3
9
2
0
24
9
Released
Description
This is a super low-profile AMS mount. It only lifts it about ½ inch, just to take a little strain off the PTFE tube for the hotend. Mine were wearing out too quickly.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
great job! supports removed easily. works perfect
0
Reply
I was very happy with these but I started to notice prints fail to stick, and it turns out that the PTFE tubing that runs to the hot end gets slowly sanded into powder and coats the bed. Attached photo was taken only after days of use :(
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRemixes (1)
© 2024 MakerWorld