Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.28mm layer, 2 walls, 15% infill

1.2 h

1 plate

4.8(26)

Boost

154

141

Released

Description

Summary

Trash can for filament with three magnets to alignment. Printed quickly n easily with a wall thickness of 1.6 mm.
It should be possible to just press in the magnets.

Mülleimer für Filament mit drei Magneten zu Ausrichtung. Schnell n leicht gedruckt mit einer Wandstärke von 1,6 mm.
Es sollte möglich sein, die Magnete nur einzudrücken.

Print Settings

Printer:

Bambu Lab X1C

                                            Rafts:                      
No

Supports:

                                            Resolution:                      
Standard

Infill:

Standard

                Filament:                                     how popular PLA                                    grau                    
                        Notes:                     
Ich verwende Filament von add:north. Die Spulen Passen in das AMS und die Drucke liefern ein sehr gutes Ergebnis.

bambulab

filament

trashcan

Comment & Rating (29)

@Rockygo46

Print Profile

0.28mm layer, 2 walls, 15% infill

The print came out almost completely perfect apart from one side where you can see a temperature problem, I think, I printed keeping the chamber closed, it's not good right with PLA? Thank you

@pocok

Print Profile

0.28mm layer, 2 walls, 15% infill

(Edited)

@BunnyLoverTom

Print Profile

0.28mm layer, 2 walls, 15% infill

It works pretty well. I really just needed something to catch all of the droppings from my printer.

(Edited)

The designer has replied

@Tridense

What could be improved, due to the 4 stars?

@BunnyLoverTom

Ultimately I felt that the design was a bit too minimalist. I felt it could be thicker on the prong clasps that went into the waste receptacle area of the printer. The back walls could also stand to be a little bit higher. About half the time I have waste filament spools landing on my workbench instead of into the receptacle. It is by no means a bad design and I don't have any intention of printing anything to replace it anytime soon... That is, unless you design a better version 😜

@M2theC

Print Profile

0.28mm layer, 2 walls, 15% infill

I like this subtitle container the most. thanks!

@zanlor64

Print Profile

0.28mm layer, 2 walls, 15% infill

Ottimo prodotto, buona soluzione. Bella l'idea delle calamite.

@user_919128029

Print Profile

0.28mm layer, 2 walls, 15% infill

perfect design and ideal with magnets.

@gduelsner

Print Profile

0.28mm layer, 2 walls, 15% infill

Es passt sehr genau in den Schacht und nimmt nicht zu viel Platz ein. Ein tolles Produkt.

(Edited)

@Lukemaster

Exactly what I was searching for! No walls that are extremely thick, magnets in the dimensions 10x3 (as I still had many), and a small elevation at the rear 💪.

(Edited)