Hex Tea Bag Dispenser with Magnets rails Remixed by Dragon3d

Remixed by

Dragon3d

Household>Office

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

3.5 h

1 plate

4.6(5)

0.2mm layer, 2 walls, 15% infill

Designer

7.3 h

2 plates

4.8(4)

Boost

Released

Description

I am inspired by others designs of the Tea Bag Dispenser but I find many issues in the design

So I made this design from scratch with a bigger tea bag size (70x80mm), internal Magnets muti options, and added the Hex wave to it with a combination connection.

* For the base Dispenser you will need only the “Box”
* For the Magnets you need 2 units of the "Magnets Rail", which will fit any Magnet size up to 12.5mm Radius and up to 2.5mm thickness

(In any of these two rails you can fit up to 4 magnets, 8 total, to get the magnetic force you need)

For the base Dispenser you will need only the “Box”
For the Magnets, you need 2 units of the "Magnets Rail", which will fit any Magnet size up to 12.5mm Radius and up to 2.5mm thickness and the rail will make a Tight fit by sliding it into the slots in the back wall.
(In any of these two rails you can fit up to 4 magnets, 8 total, to get the magnetic force you need)
To connect one Box to the other you will need 2 sets of the “Hex_Lock” M+F (No glue is needed) these locks M to F will be kicked to each other

I added the 3MF file with all the settings including the support, Also all the individual files in STL & STEP files

teabag

hex

magnets

Comment & Rating (10)

@kylix.17

Print Profile

0.2mm layer, 2 walls, 15% infill

supports failed but that's probably my issue.

@ddcardin

Print Profile

0.2mm layer, 2 walls, 15% infill

there could perhaps be slightly more room for one’s fingers to get the tea out. also the hex part to latch them together broke trying to put it together the first time. however, I’m ultimately really happy with the print itself