Tea Bag Dispenser
Copyright Claim
Tea Bag Dispenser
Boost
129
244
5
Print Profile(2)
Standard - 0.2mm layer, 2 walls, 15% infill
Designer
7.7 h
3 plates
A1 Mini - 0.2mm layer, 3 walls, 10% infill
Designer
9.2 h
3 plates
Boost
129
244
5
3
149
61
Released
Description
A tea bag dispenser in two sizes with lid! Pretty simple model, but wanted something a little more stylish than what I was finding otherwise. I hope you enjoy it too!
Hardware Requirements:
2 x M3 screws (About 10mm or longer)
Assembly:
Screw the lid on! You can keep the screws a little loose, for an easy swing lid, or you can tighten them a little so the lid stays in place as you open it.
-------
If you like my work, consider showing your love by Buying me a coffee. Additionally, if you're looking to sell prints of my design, please check out my Patreon page for more information. on.
Comment & Rating (5)
All
Print Profile
Standard - 0.2mm layer, 2 walls, 15% infill
painted 2 of these came out really good
(Edited)
0
Reply
Print Profile
Standard - 0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
looks fantastic great 👍
0
Reply
Boosted
Print Profile
A1 Mini - 0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
Standard - 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld