Bambu Lab P1P Permanent Tool Head Cover Hanger
Copyright Claim
Bambu Lab P1P Permanent Tool Head Cover Hanger
Boost
19
34
6
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
35 min
1 plate
Boost
19
34
6
0
37
28
Released
Description
Tired of unplugging your fan to work on the toolhead of your P1 series printer? Always losing loose parts? Then this toolhead cover is the one for you. Although there are other good solutions, all of them have at least one separate part. This hanger fits into the slot at the back of the cover and can stay on while printing!
Printing Instructions:
Material: PLA (Any non-flexible material should work)
Scaling: Print as it
Supports: Required for the hook
Comment & Rating (6)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Hook gets caught up on the cable chain and knocks the front off. works as a temporary holder.
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Achtung! Wenn der Haken im Druckkopf bleibt kann dieser bei der Ausrichtung im Gehäuse hängen bleiben!!! Nicht ausgereifte Idee, Druch problemlos möglich.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld