Geared Battery Box
Thorin Oakenshield
Shared by
Boost
6
9
7
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
12.3 h
3 plates
Open in Bambu Studio
Boost
6
9
7
0
19
7
Released
Description
The model includes a magazine for 6 AA batteries and a magazine for 8 AAA batteries
Remove the helper disc from the axle, put on the small gears.
If the small gears on the axle are free, glue them, first align them with each other so that the teeth sit on both large gears equally, also glue the top of the cage and the knob
You will still need 2 bearings 608 from the skates
Comment & Rating (7)
All
5/5 Rating, profile and print went very well
X1-C
Textured PEI plate
Generic PLA
The designer has replied
1
Reply
happy to hear that🙏 it would be really nice if u can vote for the profile with the stars so that your vote also counts and the profile gets a voting
(Edited)0
Reply
Replying to @Reefer
I would be more than happy to do that, I cannot seem to find the star rating, it does not show when opening the profile, I am logged in so I am unsure where I locate it. I will continue to look for it.
1
Reply
at the right top side of your profile page there u can open a slider and choose ratings there u can find your previous prints and give a rating
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Great model, printed smooth and complete with listed profile
The designer has replied
1
Reply
thanks a lot 😉🙏
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld