Bambu Lab Belt Tensioner Retainer Clip for X1, X1C, P1P

Some people are accidentally losing these little metal clips on the belt tensioners on the back of the printer, and Bambu Lab does not sell or send spares. So, I designed this which is almost a 1:1 replica of the metal clips.

Obviously you can't print this if you have already lost one of your clips but it may be a good idea to print some of these to have on hand for spares.

Print Settings

1. Recommended PETG or Nylon.
2. 0.20mm Layer Height.
3. Print with supports under the lips.
4. Print 4 of them.

NOTE:
This is designed and modeled after my clips which take an M2.5 screw. Newer Bambu Lab printers may use an M3 screw. If yours uses an M3 screw, you may need to drill out the center hole slightly larger with a drill bit after printing.