3 Piece Print of Santa's sleigh! (Yet to personally print)
I've designed this to print on most printers, the longest dimension is 150mm.
The sides should slide on the edge of the sleigh but you may need a bit of super glue to hold it strong.
I have also included a solid body part which will be easier to print without any supports and also a two-piece body.
Rafts:
No
Supports:
Yes
Notes:
To Print:
The Sleigh Body's part will need to be reorientated ... my CAD likes to randomly position the parts. I would suggest printing on the flat sides and adding support around the rim.
0.15mm layer height at 20% infill using pla