Update: I added:
- keychain/christmas ornament style version of santa. Its 67mm long, it has loop for mounting and it has slightly modified boots for better print in small scale. Please take care of good bed adhesion it has really small parts.
- chimney like look stand for your Santa. It is 5 degree angled for better balance when holding GiftBox.

It's articulated figure of Santa Clause that i happened to made.

It can:
- hang on one hand
- hang on two hands ;)
- hold accessory gift bag (.stl of it is included)
- hold Large Sweet Cain in hes left hand (.stl of cain is included).
- hold gift box (.stl of box is included).
- it can stand on its own
- give lots of joy ;)

Accessories are exchangeable and included.

I printed it in 200% scale for easier painting (i used my kids markers - I'm not professional ;p)
Printed with standard PLA White with 0.16 layer height and 0.4 nozzle on P1S.

3D PRINTING SETTINGS

0.16-0.2 layer height
0.4-0.6 nozzle (i would use 0.6 if print is going to be bigger than 150% scale
Use NO BRIM when bed adhesion is good
Use tree supports only for vertical part of GiftBag.
You have to glue two parts of Cain together.
When printing try to make GiftBox as light as possible (lighting support is a way to go), otherwise Santa will land on he's face;)
Other parts doesn't need supports.
Santa is fully printed in place without any supports.
You can try to print with make overhangs printable option enabled, but remember that it change a bit tolerances and make some accessories don't fit together. I printed mine with this option enabled and it works great.