I wanted a side spool holder that doesn't require the BL metal bracket wich i didn't have.
After searching for different models, none was satisfying or didn't work fine (Filament too hard to pull and leads to under extrusion).
So, i came up with the idea or merging two different design all together to do what i intended.
I simply used the idea from Poli27 but I’ve redone the whole design from scratch with Onshape.
I adapted the design so i can fit the spool design from Termiman.
BENEFITS:
BOM:
PRINTING:
Support required for the roller (under and at both ends) *This part will require a little bit of sanding for the bearing to fit
Other parts only need support for the nut’s holes, so they are clean of any lost filaments.
Keep the profile's orientation and settings for better strenght.
I used Sunlu PLA+ which is enough for the weight from a 1kg spool.
Make sure to use the profile settings or use PETG if you prefer.
AMS:
There seems to be different versions of the AMS. So before you print the clamps, check the rib size of your AMS.
This should enable all model to be compatible but i only have one model, so this have to be checked.
ASSEMBLING:
INSTALLING:
NOTE:
This design is compatible with the Y connector "The Smoothy". Longer PTFE tube may be required with another Y connector.
Go check this excellent design: https://makerworld.com/en/models/18174#profileId-17021
SPECIAL THANKS:
Big shout out to Poli27 and Termiman for their work that inspire this remix.
Go check the original design:
https://makerworld.com/en/models/65069#profileId-68397
https://www.printables.com/fr/model/243318-ender-5-plus-filler-filament-holder-compact-update