Remix of Squash ball feet for Prusa Mini. All brackets bolt into aluminum extrusions and support the electronic's box.

Highlights:

• Massive Noise Reduction
• Improved Stability (Lifting the magnetic sheet won't tilt the printer)
• 6 Support Points without increasing operational footprint.

This is inspired in https://www.thingiverse.com/thing:4752965 from jrjonescan, I love the weight distribution and support points choice. But it was too bulky, so I recreated the low profile from Vektor.

• Print 3x Single Foot (If you are going to use the Spool holder print only 2x)
• 1x each other model

You will need:

• 6x Squash Balls (double yellow dot)
• 5x M6 x 12mm Bolts
• 5x M6 T-Nuts
• *If using the spool holder setup, you will also need:
  • 2x 608 bearings. Alternatively, you can reuse the originals from the mini Spool Holder.
  • 1x of the Original Prusa Mini Foam Feet (The spool holder includes a slot)

Spool Holder:

This is a remix of the popular Spool Holder from Max with the Squash Ball foot + the "Filler" Filament Roller.

Print instructions

• .25 layer
• 3+ perimeters
• ±30% infill
• Minimal Support ( set overhang threshold to 5º, so supports is added only to critical areas)
• PLA / PETG