Part for repairing the Moccamaster Technivorm coffee container lid holder.

• Print in ABS or high-temperature material. PET-G is not tested but will probably work. Let us know if you test it!
• Recommended: Use 3DLAC or Glue Stick even on the textured plate with ABS.
• Parts are oriented for best strength. Do not re-orient and do not use support material.
• Only print the Designer configuration and one of the plates (see below for help choosing).

Available configurations

• Both Broken (recommended): If both the tabs are broken, use side pliers to remove any remaining plastic and leave the flat surface (see image).
  If only one tab is broken, I'd recommend cutting away the healthy tab with side cutter pliers and using this configuration as well.
  The part snaps into place with a tight fit and glue is unnecessary. The fit against the lid is harder than the original (which I like).
• Left Broken / Right Broken: If just one tab is broken, you can choose to print one of these. Note that these parts need to be glued to the flat surface!