This is a remix of PeakPoke's riser which is an awesome print and I really appreciate you sharing!
A few tweaks I made
- for me the glass wasn't fitting correctly so I opened up the width and length to accomodate
- I added channeling for the LED wiring under the frame
- I added a slot holder for a Adafruit QT PY Pico Board that I use to control WLED
- Added a small notch on the backside to hold a 10mm magnet
The print in general fit together but needed a bit of sanding here and there. I only used Bambu filament so if you use other filament print at your own risk. Otherwise, hope you enjoy!